Table of Contents
Advertisement
Available languages
Available languages
English
Intended Use
The pipe threader is designed for threading pipe and
conduit using appropriate cutting dies.
DO nOT use for drilling or driving fasteners.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
This pipe threader is a professional power tool.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Attaching the Die (Fig. B)
WARNING: Inspect the cutterheads of the die for
wear, deformation, chips or other issues. Dull or
damaged cutterheads increase the amount of force
required, produce poor quality threads and increase
the risk of injury. Only use D
Other dies may not fit correctly, increasing the risk of
damage or personal injury.
1. Insert the die on the side of the tool as shown in Fig. B.
2. Using both hands with equal pressure, push the
die
6
inside the die head interface
of the die head sits flush against the ridge of the die
head interface.
3. Rotate the die slightly so the latch engages.
Fig. B
Removing Die (Fig. B)
nOTE: If the die becomes stuck use a piece of wood or
a dead blow hammer to remove the die from the die
interface. Do not use metal tool to remove the die. Metal
tools could damage the die interface.
1. Place the pipe threader on a flat surface. The die
should be facing down.
2. Using both hands with equal pressure, push the die out
of the die interface
7
and free from the friction hold.
8
WALT recommended dies.
e
7
until the ridge
7
6
6
Assemble Clamp (Fig. C, D)
Assemble Support Arm
1. Thread the support arm
support arm mount
27
.
2. Tighten the support arm with an open end wrench.
Assemble Die Arm
1. Unthread the preassembled wing nut
arm saddle
17
.
2. Attach the die arm
8
to the die arm saddle with the the
die plate
9
facing toward the end of the pipe. Thread
and tighten the preassembled wing nut to secure the
die arm into place.
Fig. C
Fig. D
18
Mounting Clamp to Pipe (Fig. E, K)
WARNING: Properly support the pipe in a stand or
securely brace in place to reduce the risk of the pipe
falling or tipping.
WARNING: Always attach the clamp before using the
pipe threader.
WARNING: Always use the die arm when starting
the thread as shown in Proper hand Position.
Do not substitute your hand for the die arm to start
the thread.
1. Set the adjustment
on the clamp
11
appropriate pipe diameter following the size
indicator
28
.
2. Place the clamp over the pipe
the pipe aligns with the end of the support arm
in Fig K.
3. Put pressure on the clamp
the pipe. If not secure, make any needed adjustments
10
completely through the
from the die
18
10
27
9
8
17
for the
12
20
so that the end of
10
as
to properly secure it to
12
Advertisement
Table of Contents
