Advertisement
3.
OPERATION.
3.1.
ZERO SETTING.
Prior to operation, perform a zero setting. To do this close the jaws (fig1.1.) then press the
'ZERo' button (fig1.4.); the gauge has been set to zero when the LCD displays '0.00'.
Note: After zero setting, the gauge retains this setting until the 'ZERo' button is pressed
again or the battery is removed.
3.2.
PRODUCT USAGE.
3.2.1. Ensure all surfaces are clean before measuring.
3.2.2. Switch on the gauge by pressing the on/off button (fig.1.3.) and set units using unit
selector button (fig1.6).
3.2.3. for disc measurement: open the external jaws to clear the lip and close onto the disc
surface. The reading may be saved by pressing the Hold Button (fig1.5), allowing
withdrawal over the lip. A second press returns to the current reading.
3.2.4. for drum measurement: extend the internal jaws until they meet the inner surface of the
drum.
3.2.5. The use of excessive force will lead to innacurate measurement and damage to the gauge.
4.
MAINTENANCE.
4.1.
BATTERY INSTALLATION/REPLACEMENT (fig.2)
NoTE! The battery should last for one year of
continuous use. If the display is blank or the digits are
flashing the battery voltage is too low, replace the
battery with a new SR44 battery. If the digits do not
change when buttons are pressed or probe is moved,
remove the battery for 1 minute to reset the unit. The
battery should be removed if the gauge is not to be
used for a long period of time.
4.1.1. Remove battery cover by sliding backwards and lifting
off.
4.1.2. Remove exhausted battery and fit replacement with +ve
side uppermost. Place the battery into the recess and
press into place. Slide the cover back and click home.
4.1.3. Dispose of old battery in a safe and approved manner.
Do not burn.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycle centre and disposed of in a manner which is compatible with the environment.
When the product is no longer required, it must be disposed of in an environmentally protective way.
Do not incinerate battery as it may explode when exposed to fire.
Do not attempt to open battery.
Contact your local solid waste authority for recycling information.
Environmental Protection.
fig.2
Advertisement
