Preparation; Making Connections; Connecting Audio Equipment - Tascam Mixcast 4 Reference Manual
Podcast recording console
Hide thumbs
Also See for Mixcast 4:
- Owner's manual (124 pages) ,
- Instructions (2 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
3 - Preparation
Making connections
Connecting audio equipment
The following is an example of connections with this unit.
Precautions before making connections
o Carefully read the operation manuals of the devices to be connected and then connect them correctly.
o Before making connections, turn this unit and all equipment to be connected off (standby).
o Install all connected devices, including this unit, so that they are powered from the same line. When using a power strip or similar device, be sure to
use one that has high current capacity (thick cable) in order to minimize fluctuations in power voltage.
V CAUTION
Before turning the power on or connecting audio equipment, set the following knobs and faders on this unit and the knobs and faders of the devices
being connected to their lowest values. Failure to do so could cause sudden loud noises from monitoring equipment, and this could damage the
equipment or harm hearing.
o Channel faders (e), PHONES
Connection example
Note: For details about q–g in the illustration above, See "Top panel" on page 5 and See "Rear panel" on page 6.
8
TASCAM Mixcast 4
–
knobs (6), MONITOR OUT knob (5)
Back
Front
Advertisement
Table of Contents
