Page 1
4599 Safety Ensure that Health and Safety, local authority and general workshop practice regulations are adhered to when using tools. DO NOT use tools if there is any sign of damage Maintain tools in good and clean condition for best and safest performance. Ensure that a vehicle which has been jacked up is adequately supported with axle stands.
Page 2
This Torque adaptor can be used with any 1/2”D power bar or ratchet. The tool enables the correct torque to be set on any fastener, ranging from 40-200Nm. INSTRUCTIONS Peak Calibration mode This will show the reading as the torque increases, and then hold at the The Adaptor will enter into Calibration mode if Mem and O are pressed highest reading simultaneously.