Agilent Technologies 1200 Series User Manual page 25

In an Agilent 1200 Series system, the individual modules are connected through a CAN
N O T E
cable. The Agilent 1200 Series vacuum degasser is an exception. The vacuum degasser can
be connected via the APG remote connector to the other modules of the stack. The AUX
output allows to monitor the vacuum pressure in the degasser chamber. An Agilent 1200
Series control module can be connected to the CAN bus at any of the modules in the
system except for the degasser. The Agilent ChemStation can be connected to the system
through one GPIB or LAN cable at any of the modules (except for the degasser), preferably
at the detector. For more information about connecting the control module or Agilent
ChemStation refer to the respective user manual.
1200 Series VD User Manual
Figure 5 Rear of the Vacuum Degasser
Figure 6 Front of the Vacuum Degasser
Installing the Vacuum Degasser
Installing the Vacuum Degasser
3
25