Advertisement
Quick Links
Thank you for purchasing the Xwave repeater. The repeater works on the 433Mhz frequency
range and only repeats the signals from a known Xwave device. The unit can also indicate that
signals are being repeated by turning on the button that corresponds to the channel being
repeated or a beep each time a signal is repeated.
Figure 1: Xwave repeater
A.
Show channel
being repeated
Not Used
Battery charging
indicator
B.
Stand
C.
DC Charging
Plug
700-604-02A Xwave Repeater Manual
Beep when a signal
is repeated
Wireless channels
Not used
Transmit Indicator
Housing Screw
Open
Advertisement
Related Manuals for IDS Xwave
Summary of Contents for IDS Xwave
- Page 1 Thank you for purchasing the Xwave repeater. The repeater works on the 433Mhz frequency range and only repeats the signals from a known Xwave device. The unit can also indicate that signals are being repeated by turning on the button that corresponds to the channel being repeated or a beep each time a signal is repeated.
- Page 2 Figure 2: Batteries Learning detectors into a channel Six Xwave detectors can be learnt into any of the six channels. (One detector per channel.) Note: Please see detector manuals for information on tampering. Make sure the system is in idle mode by making sure none of the visual modes are selected.
- Page 3 Chime mode is exited and all deselected chime on repeat channels are cleared. Visual indication on repeat The Xwave repeater can be set in a visual mode to visually indicate if a channel is being repeated. TURN ON VISUAL INDICATORS Press the visual indicator button once.
- Page 4 (Suggestion: use the unit until its empty again, before re- connecting charger). Technical specs Wireless transmission Frequency: 433MHz Wireless transmission distance: 100m line of sight Batteries: 3 x ‘AA’ NiMH 1.2V, 2100mAH DC charge input 12V, 1.5A Current Draw: Standby: 35mA Alarm: 100mA 700-604-02A Xwave Repeater Manual...