ZincFive UPStealth 2 User Manual

Getting Started Guide
Welcome to your UPStealth 2 Uninterruptible Power Supply (UPStealth 2). The following is important
information to know prior to getting started with your product.
UPStealth 2 User Manual
Take the time to read the UPStealth 2 User Manual, it is provided with your product to help you
understand how to safely and properly prepare, install and operate your UPStealth 2. A copy of the
manual can also be found at zincfive.com/support.
Pre-Installation & Installation Checklist
Provided in your Getting Started Guide are two documents, the Pre-Installation Checklist and
Installation Checklist. Utilize the Pre-Installation Checklist to make sure your site is ready for installing
the UPStealth 2, and the Installation Checklist will take you through the proper and safe installation of
your equipment.
UPStealth 2 Updates
Firmware and Software updates for the UPStealth 2 are available to download via
zincfive.com/support/upstealth2updates. Take the time to fill out the form on this page so you can be
notified of future updates.
UPStealth 2 Software Network Configuration
The UPStealth 2 Software can be used to locally or remotely manage and monitor the status of an
individual UPStealth 2. To connect to the UPStealth 2 Software, you will need to configure your
computer's Network settings. Below are instructions on how to connect to the web server via your
computer's browser in the UPStealth 2 UPS with your Windows or Mac computer. Once completed,
enter your UPStealth 2 IP address (192.168.1.51) into your web browser and log in to the UPStealth 2
using the following defaults.
Username: admin
Password: user
WINDOWS
•
Click on Settings
•
Click on Network and Internet
•
Click on Ethernet
•
Change Adapter Options
•
Select an ethernet port, right click and select
Properties
•
Find and select Internet Protocol Version 4
(TCP/IPv4)
•
Click Properties
•
Select the circle "Use the following IP Address"; then
insert 192.168.1.52
•
Insert Subnet Mask: 255.255.255.0
•
Click on Okay
• Click on Close
zincfive.com
MAC
•
Click on the Apple Icon in the top left and select
System Preferences
•
Click on Network
•
Click on the Configure IPv4 dropdown and select
Manually
•
In the IP Address field, insert 192.168.1.52 (notice
this is slightly different from your UPStealth 2 UPS
1000W IP Address of 192.168.1.51)
•
In the Subnet Mask field, insert 255.255.255.0.
© 2020 ZincFive, Inc. 503.399.3517