ETI THERMADATA WIFI Quick Start Manual

BATTERY REPLACEMENT
You will need a flat-headed screwdriver (provided in box).
1. Place the instrument display-down on a solid surface.
2. Unscrew and remove the battery cover.
3. Remove batteries (top one first).
4. Fit new batteries, noting the polarities marked on the plastic.
5. Replace battery cover, then tighten the battery screw.
6. Dispose of the old batteries appropriately.
If this is the first time the instrument has been used then it will need setting up in
ThermaData Studio. If it has previously been used then it will attempt to reconnect
®
to the WiFi and continue recording. Please note that the instrument may take a few
minutes to connect.
WARNING: IPA and other solvents may cause damage to the case and screen of
this instrument.
INSTRUMENT RECORD CARD
FOR THERMADATA HUMIDITY INSTRUMENTS ONLY
®
REFERENCE
TEMPERATURE
HUMIDITY
Serial No. _____________________________________________________
Calibrated by _____________________ Date ______________________
This instrument has been checked or calibrated against reference instrument(s) calibrated by a
UKAS Accredited Calibration Laboratory.
PLEASE NOTE: Due to regular software updates, please visit the download page on our
website etiltd.com/downloads to ensure you have the latest version of ThermaData
Front cover products from left to right: ThermaData TD2F (298-111) / ThermaData TD (298-001) /
ThermaData TD2TC Type K (298-121) / ThermaData TD2TC Type T (298-721) / ThermaData Pharm
TD2F (298-111-PHM)
Manufactured by
Electronic Temperature Instruments Ltd
Worthing · West Sussex · BN14 8HQ
01903 202151 · sales@etiltd.com · etiltd.com
INSTRUMENT
Studio.
®
545-922/19.01.21
THERMADATA WIFI
®
Quick Start Guide