Harness Installation - DeWalt DXSP190652 Instruction Manual

ENGLISH
20. Replace tank cap, filter (See Fig. II) and pump handle.
(Fig. W)

Harness Installation

1. For each side, remove the small plastic clips from the
two shoulder strap loops and thread each loop through
the slots at the top of the carry handle. Replace the
clips through the loops and pull strap securing the two
shoulder straps in place. (Fig. JJ)
2. To install lower end of the straps, remove strap from
top portion of buckles and place around the foot stand,
starting from underneath. (Fig. KK)
6
Fig. II
Fig. JJ
Fig. KK
3. Loop strap through the first section of buckle. (Fig. LL)
4. Next loop strap through other section of buckle and
tighten (Fig. MM). Adjust the shoulder pads and strap
length for a comfortable fit.
Fig. LL
Fig. MM