Monitor Installation - Boss Audio Systems BV7.3FLIP User Manual

Monitor installation

CAUTION: Make sure the
screws are NOT long enough
to go through the roof!
Thread all the wires through the
round hole in the center of the
mounting plate.
Install the monitor onto the
mounting plate, using the four
screws provided.
INSTALLATION TIP
Make a MOUNTING BRACKET out of wood. This bracket mounts under the headliner,
and provides a mounting surface to which the housing of the flip-down monitor can
be attached.
If you have any doubts about this type of installation, please consult
your local mobile electronics retailer. Making holes in the roof of
your vehicle will cause damage which is expensive to repair.
Using the four black self-tapping
screws provided, attach the monitor
mounting plate by screwing through
the headliner and into the existing
roof supports or the wood bracket
you made (see TIP below).
1/2" black self tapping
sheet metal screws
1" silver finish
threaded machine
screws
BV7.3FLIP • BV7.31RF • BV8FL • BV8WFLIP • BV8IRF User's Manual - page 9