easyteck G501 Quick Start Manual

GENERAL INTRODUCTION
This phone adopts the up-to-the-minute integrated circuit, with superior craftwork and stable
capability. Please read the manual carefully for proper use.
SAFETY INSTRUCTION
When using your telephone, please follow these basic safety precautions to reduce the risk of
fire, electric shock or injury to persons.
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the products.
3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or
aerosol cleaners. Use a damp cloth for cleaning.
4. Do not use this product near water (for example, near a bath tub, kitchen sink or swimming
pool).
5. Do not place this product on an unstable cart, stand, or table. The product may fall, causing
serious damage to the product.
6. Never spill liquid of any kind on the product.
7. To reduce the risk of electric shock, do not disassemble this product. If service or repair
work is required, contact your qualified technician.
8. Do not use the telephone to report a gas leak in the vicinity of the leak.
FUNCTIONS
Desk/wall mountable
Last number redial
Flash function
Pause function
OPERATION
1) Preparation
1.1 Connect the line plugs into phone line jack and the other plug to connect to the wall jack.
1.2 Insert the handset coil cord into the phone jack at the bottom.
2) Receiving
As it rings, pick up the handset from the cradle to receive, and put back the handset to hang up
to end the conversation.
3) Dialing
Pick up the handset, dial the desired number as hearing the dialing tone, then if you hear the
long tone like "do—do", the line has got through. If you hear the short tone like "do... do... do",
busy tone, you could press the hook switch then press REDIAL to dial it out again after some
time. You could repeat the above process till getting the line through.
4) Redial
Press the REDIAL button the unit will redial the last number automatically.
5) Pause
If you want to dial out the extension phone, press shift key (normally "0" or "9") + PAUSE +
desired number, then you could just press REDIAL to dial out when the dialed number is busy.