Changing Your Computer's Wireless Settings - Brother NC-2200W Network User's Manual

Changing your Computer's Wireless Settings

Before you can use the Brother Printer/MFC/DCP in a wireless
network, the NC-2200w must be configured to match your network
configuration.
To configure the NC-2200w from a wireless computer on your
network, you must temporarily change your current wireless settings.
Before changing the current wireless settings of your computer, we
recommend you make a note of your current wireless network
settings. You will need to return to these settings at the end of
configuring the print/scan server.
We recommend you to contact your network administrator if
you need assistance with your computers wireless settings.
To communicate with the un-configured NC-2200w change your
wireless computer settings to:
Communication mode:Ad-hoc (channel 11)
Network name (SSID/ESSID):SETUP (case sensitive)
Encryption:None
Before installation, if you are using Personal Firewall
software (e.g. the Internet Connection Firewall available in
Windows XP), disable it. Once you are sure that you can
print, re-start your Personal Firewall software.
®
Windows 98/Me/2000 Users
Please refer to your wireless card manufacturer instructions for
changing the wireless settings. And then go to Step 3 Configuring the
Print Server.
If you are using Windows
in Wireless Ethernet capabilities, use the following steps for each Operating
System.
® ®
XP or Mac OS X 10.2.4 and you are using its built
NC-2200W WIRELESS SETTING 2 - 9