Advertisement
Operation
Powering the DVD Player
•
This device is powered by a rechargeable lithium ion battery.
•
To charge the battery, first make sure that the player is switched OFF . Connect the DC jack of the AC/car
adaptor to the socket and the other end to an appropriate electrical outlet.
WARNING: Only use the supplied AC/car adaptor for charging the DVD Player. Charging with a different
adaptor may cause damage or an explosion.
WARNING: Do not leave the DVD player unattended while charging.
•
During charging, the red LED light will illuminate indicating that the battery is being charged. It takes
about 4 hours to fully charge the battery. With a full charge, the player can be used continuously for up
to 120 minutes without recharging.
•
Once fully charged you can disconnect the device from the charger, or leave the charger connected and
run the player on the mains electricity to save battery power.
•
You can also recharge and run the player in the car with the supplied car power adaptor, which
attaches easily to the car's cigarette lighter.
The car adaptor can only support vehicles with 12V output. Larger vehicles that may use 24V output
are not supported.
NOTE: During playback, it is normal for the appliance to produce heat. Avoid using for an extended period
of time.
OPERATION | 13
Advertisement
