HQTELECOM UBlocker WL Setup Instructions

Ultimate Call Blocker (UBlocker) WL Setup Instructions
Congratulations on your purchase! Please read this entire document before installing
your UBlocker WL.

1) CONNECTING YOUR PHONE LINE

Connect Phone Adapter (included) to any of the USB port on the UBlocker. On the
other side, plug the phone cable (included) to your phone line (modem or wall jack):
Note: Please note that the Phone adapter has 2 Sockets labeled LINE and PHONE.
Make you connect the LINE to your phonejack with dialtone. You may connect your
existing PHONE (base or handset) to the PHONE port. NOTE: Having a phone
connected on the phone adapter is not required for the UBlocker to work properly.

2) CONNECTING POWER

Connect the power adapter (included) to the microUSB port on the UBlocker, as
shown below:
TIP: We recommend that you use a UPS (battery-powered power supply) in order to
extend the life of your UBlocker. If not available, please use a surge protected outlet.
Next, you UBlocker can be installed in 2 ways: 1) LAN / Ethernet or/and 2) WIFI
Note: You may also connect them both ways for redundancy purpose.