Technical Data - AEG LTM7C7331D User Manual

Problem
The washing results are
not satisfactory.
Too much foam in the
drum during the washing
cycle.
After the washing cycle,
there are some deter-
gent residues in the dis-
penser drawer.
The drum light does not
go on.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.

14. TECHNICAL DATA

Dimension
Electrical connection
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, ex-
cept where the low voltage equipment has no pro-
tection against moisture
Water supply pressure
Water supply
Maximum Load
Energy Efficiency Class
Spin Speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
Possible solution
• Increase the detergent quantity or use a different deter-
gent.
• Use special products to remove the stubborn stains before
you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• Reduce the quantity of detergent.
• Make sure that the flap is in the correct position (left for
powder detergent - right for liquid detergent).
• Make sure you have used the detergent dispenser accord-
ing the indications given in this user manual.
• Make sure that the LED lamp is not burned. To replace it,
contact the Authorised Service Centre.
Width/ Height/ Depth/
Total depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
1)
Cotton
Maximum
400 mm/ 890 mm/ 600 mm/ 600 mm
220 - 240 V
2200 W
10 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
7 kg
A+++ -20%
1300 rpm
ENGLISH 29