AEG LTM7C7331D User Manual page 16

16 www.aeg.com
cheaper electricity tariffs are available.
In some programmes the rinses are
performed with more water.
The display shows the indicator
The lid stays locked. The drum turns
regularly to reduce creasing. You
must drain the water to unlock the lid.
Touch the Départ/Pause button: the
appliance performs only the draining
phase.
The appliance empties the
water out automatically after
approximately 18 hours.
7.7 Taches/Prélavage
Press this button repeatedly to activate
one of the two options.
The relevant indicator goes on in the
display.
• Taches
Select this option to add an anti-stain
phase to a programme in order to
treat heavily soiled or stained laundry
with stain remover.
Pour the stain remover into
compartment
will be added in the appropriate
phase of the washing programme.
This option can increase
the programme duration
and is not available with a
temperature lower than
40 °C.
• Prélavage
Use this option to add a prewash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust , mud and other
solid particles.
This option can increase
the programme duration.
7.8 Rinçage Plus
With this option you can add up to 3
rinses accordingly to the selected
washing programmes.
.
. The stain remover
Useful for people allergic to detergents
and in areas where the water is soft.
The indicator shows the selected
number of rinses.
This option increases the programme
duration.
If the Rinçage Plus is set as a
default option and you
select a compatible washing
programme, the display
shows . In this case, by
pressing the Rinçage Plus
button , it is possible to add
just one rinse.
7.9 Skipping phase button
(Options)
By touching this button you can set:
• Rinçage option. The appliance
performs only the rinsing phase , the
spinning and the draining phases of
the selected programme.
• Essorage option. The appliance
performs only the spinning phase of
the selected washing programme.
• Vidange option. The appliance
performs the only draining phase of
the selected washing programme.
At firth touch the appliance
proposes the default setting
of the washing programme
again.
7.10 Vapeur Plus
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric creasing
and facilitates the fabric ironing.
The indicator flashes on the display
during steam phase.
This option can increase the
programme duration.
When the programme stops the display
shows a zero , the indicator
steady on and the indicator
flashing. The drum performs smooth
is
starts