Page 1
User Instruction Manual Oxford Smart Monitor ® To avoid injury, read user manual prior to use. For alternative languages, contact your authorised service provider.
Joerns Healthcare for further advice. WARNING Do not attempt to use the Oxford Smart Monitor without first understanding this manual. The CE Mark: The Oxford Smart Monitor carries the CE mark and complies with the following EC directives: • Medical Device Directive (93/42/EEC) •...
Oxford ® English Smart Monitor 2. Oxford Smart Monitor Emergency Stop Button Raise & Lower Buttons Legs Open / Close Buttons Emergency Raise & Lower (Model dependent) Redundant Controls User Handset Legs Open / Close Redundant Controls (Model dependent) User Handset...
• 1 x M5 x 8mm Long Fixing Screw • 1 x Battery Pack • 1 x User Manual NOTE: The Oxford Smart Monitor can only be operated with the User Handset supplied. WARNING The Oxford Smart Monitor requires calibrating prior to use. Specific calibration is dependent on lift type and must be performed by an authorised service provider only.
DO NOT exceed the safe working load of the lift and/or sling. To raise or lower the boom following the retro-fit of an Oxford Smart Monitor, simply press the raise and lower buttons on the User Handset (Fig. 2). If your lift incorporates powered leg positioning, the legs can be opened/closed using the appropriate button on the User Handset (Fig.
Smart Monitor 5. Smart Monitor Display The Oxford Smart Monitor has the option to read out information via the LCD display screen. It is possible to read out total lifting cycles, total work done, overloads and number of days since last service, which can be used to quickly and easily evaluate the condition of the lift actuator.
Page 8
Oxford ® English Smart Monitor On-Board Redundant Controls On-board redundant controls enable the lift to be raised or lowered in the event of an emergency. If your lift incorporates powered leg positioning, there are redundant controls to both open and close the legs.
Oxford ® English Smart Monitor 6. Maintenance Cleaning Clean with ordinary soap and water and/or any hard surface disinfectant. Harsh chemical cleaners or abrasives should be avoided as these may damage the surface finish of the product. Avoid wetting any of the electrical parts. After cleaning, the unit should be thoroughly dried.
If you are in doubt as to where your product was purchased, Joerns Healthcare can trace the supplier if you quote the serial number of the lift. Contact details can be found on the rear cover of this manual.
Need help?
Do you have a question about the Oxford and is the answer not in the manual?
Questions and answers