Figure 1 XLINK-50 XLINK-50 needs to be used in pairs. The selection of antenna is determined by the scenarios that it is applied to. When used on aircraft, the sky end is referred to as the Air Unit, whereas the ground end is called the Ground Unit.
2.Industry Application XLINK-50 needs to be used in pairs. The selection of antenna is determined by the scenarios that it is applied to. When used on aircraft, the sky end is referred to as the Air Unit, whereas the ground end is called the Ground Unit.
User Manual 3.2.Performance Xlink-50 supports a variety of communication code streams, which can be selected according to the needs of actual mission. Xlink-50 supports two-way communication, the specific description is as follows: (1)From the air end to the ground end, it supports the transmission of large bit stream data through the IP network port, which can be used for video communication;...
Page 7
FOXTECHXLINK-50 Long Range Video/Data Wireless Transmitting System User Manual Figure 3 Pin identification number...
Page 8
FOXTECHXLINK-50 Long Range Video/Data Wireless Transmitting System User Manual...
FOXTECHXLINK-50 Long Range Video/Data Wireless Transmitting System User Manual 5.Mechanical characteristics See Table 7 for mechanical characteristics, and Figure 4 for specific product dimensions and installation.
Page 10
FOXTECHXLINK-50 Long Range Video/Data Wireless Transmitting System User Manual Figure 4 Dimensions...
FOXTECHXLINK-50 Long Range Video/Data Wireless Transmitting System User Manual Installation Instructions (1)M3*10GB/T818, 4PCS (2)cross head screwdriver (3)The depth of threaded hole should be reserved at east 5mm (4)Torque requirement 6±0.5Kgf; 6.Quick Start 6.1 UI Configuration XLINK-30 has different data rates, which needs to be configured as needed. STEP 1 Power on XLINK-30, and link it with PC by Ethernet.
FOXTECHXLINK-50 Long Range Video/Data Wireless Transmitting System User Manual 6.2.Pairing In the point-to-point application scenario, after air unit and ground unit are powered on, the two modules need to successfully establish a link before they can communicate. The following describes the link establishment process: Step 1 After one unit powers on, the SYNC LED indicator turns green.
Page 13
FOXTECHXLINK-50 Long Range Video/Data Wireless Transmitting System User Manual Appendix -1 Figure 7 diagram of J30J socket pin definition...
Need help?
Do you have a question about the XLINK-50 and is the answer not in the manual?
Questions and answers