Parts Of The Heater; Operating Instructions - FACTO 6629016 Operator's Manual

To operate, connect to a properly polarized outlet only. Match wide blade of plug to wide slot and
fully insert. Be sure to plug into a 120V AC, 60Hz outlet.
NOTE: THE HEATER WILL NOT OPERATE UNTIL THE POWER THE UNIT IS PROPERLY
PLUGGED INTO A POLARIZED OUTLET AND POWERED ON ( SEE SECTION ON
POLARIZED PLUGS UNDER SAFETY INSTRUCTIONS ).
YOUR HEATER IS EQUIPPED WITH 3 CONTROL SETTINGS.
Low heat setting
High heat setting
Heat setting Controls
HIGH HEAT SETTING
•
The dial in this position will set temperature to HIGH heat output. The unit is ON and
the power indicator light will be illuminated.
•
Use this setting for faster warm-up of a room or for colder weather.
LOW HEAT SETTING
The dial in this position will set temperature to LOW heat output. The unit is ON and the
•
power indicator light will be illuminated.
•
Use this setting to reduce electrical consumption and to prevent the room from
becoming too warm.
OFF
Turn the dial counter-clockwise to power the heater OFF.
•
At this setting, the unit will not produce heat and power indicator light will be OFF.
•

PARTS OF THE HEATER

OPERATING INSTRUCTIONS

Power OFF
Parts of the Heater
1. Power indicator light
2. Control Dial
3. Safety Grille
5