Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Lorenz trapeo
- Page 1 LORENZ Solar module mounting system ® Installation manual LORENZ trapeo ®...
- Page 2 Welcome Welcome to LORENZ ® • Suitable for use on all trapezoidal sheet Thank you for deciding to use a product from the LORENZ fami- ® geometries, on roofs with a pitch of up to ly. LORENZ trapeo is a simple, flexible mounting system for tra- ®...
-
Page 3: Table Of Contents
Sitemap 1. Planning guide 1.1 Orientation and roof pitch ....4 1.2 Roof layout .......... 4 1.3 Plan for mounting system...... 5 1.4 Stringing plans ........5 1.5 Planning for lightning protection and equipotential ....6 2. Preparations 2.1 Test modules ........6 2.2 Check inverters ........ -
Page 4: Planning Guide
Planning the roof layout level, please contact LORENZ Montagesysteme GmbH. Please note that the LORENZ® trapeo system described here is suitable only for parallel mounting. Any change in the angle of the modules can have a detrimental effect on the statics and is therefore not permitted. -
Page 5: Plan For Mounting System
U-shaped trapeo rail 25x46x400mm.Set (Standard) clamps. 139511200 U-shaped trapeo rail 25x46x740mm.Set (for 5“ modules) Planning the distance between rails 139511400 U-shaped trapeo rail 25x46x940mm.Set (for 6“ modules) The following different options are possible:... -
Page 6: Protection And Equipotential
Please note that only specialist electri- cal companies are permitted to connect the device to the grid. Attach connectors to the ends of the DC cables. LORENZ Monta- gesysteme GmbH supplies crimping pliers and mounting tools from a variety of suppliers for this purpose. -
Page 7: Mounting The U-Shaped Rails
Centre the U-shaped rail Fit all the other U-shaped rails in the way described. Install the rail Components required Tools required Folding rule U-shaped trapeo 25x46xxxxmm.Set 13 951x000 Cordless screw- driver Soloclip (optional) Cable ties (optional) -
Page 8: Laying The Cables
Installation Montage der Dachhaken Begin by mounting the top row of modules. To do this, fit the clamps into the U-shaped one side and press down on the other Laying the cables side of the clamp until you hear the click. Make sure the clamp is in the right position. -
Page 9: Connecting The Modules
These instructions provide information on the correct Make sure that the gap between the side of the module frame and way to install the LORENZ -mounting system, including the module clamp is not larger than 1 mm. Otherwise there is a ®... -
Page 10: Safety Instructions
All parts should be used only for the fitting of solar modules. The fitting of roof ladders, roof treads and the construction of safety equipment such as catch nets is not permitted using LORENZ II In this chapter, we provide an overview of the key safety informa- components. -
Page 11: Safety Regulations When
Safety instructions Safety harnesses Safety regulations when working on roofs Use safety harnesses if scaffolding and barriers are not feasible for technical reasons relating to the work being done or the buil- All rooftop work should be carried out professionally and safely. ding in question. -
Page 12: Warranty Certificate
(1) failure to adhere to LORENZ instructions with regard to the installation, operation or maintenance of the LORENZ A claim on the warranty may be asserted only as long as LORENZ is Mounting System; assigned ownership of the replaced original component / (2) improper and inappropriate handling of the LORENZ Moun LORENZ Mounting System during replacement. - Page 13 6. CLAIMING WARRANTY REPAIRS Claims on this warranty are to be made in written form to LORENZ via the seller of the LORENZ Mounting System. If the claim cannot be made via the seller, the claim may alternatively be made directly to LO- RENZ in written form.
-
Page 14: Garantiezertifikat
Gründe verursacht systems-LORENZ entsprechen. wurden: Der Anspruch aus der Garantie besteht nur, soweit LORENZ mit dem (1)Nichteinhaltung von LORENZ-Anweisungen hinsichtlich der Austausch das Eigentum an dem ausgetauschten Originalbauteil / Montage, dem Betrieb oder der Wartung des Montage- Montagesystem-LORENZ übertragen wird. - Page 15 Garantiezertifikat geschäden, Betriebsunterbrechung und entgangenen Gewinn. Der Haftungsausschluss gilt dann nicht, soweit LORENZ zwingend haftet, z. B. nach dem Produkthaftungsgesetz, in Fällen des Vorsatzes, der groben Fahrlässigkeit, wegen der Verletzung des Lebens, des Körpers oder der Gesundheit oder wegen der Verletzung wesentlicher Ver- tragspflichten.
- Page 16 LORENZ-Montagesysteme GmbH Alfred-Nobel-Straße 7-9 50226 Frechen Tel.: +49(0)221 126107-0 Fax: +49(0)221 126107-19 www.lorenz-montagesystem.de E-Mail: info@lorenz-ms.de...