Power On/Off - YUNEEC TYPHOON H PLUS Quick Start Manual

Power ON / OFF
NOTICE:
Please make sure all firmware is the latest version. Firmware and
the user manual may be downloaded from web site: www.yuneec.com. The
quick start guide does not replace the user manual.
Turn on the ST16S, and then press the power button on TYPHOON H Plus.
Release the button when the aircraft emits a rising tone. Power on the ST16S
before powering on the UAS.
Take Off
Press and hold the START/STOP
button for about 3 seconds to start
the motors in angle mode.
POWERING
ON ST16S
POWERING ON
TYPHOON H
PLUS
OPTION 1:
Slowly raise the left-hand stick to take
off.
OPTION 2:
Tap the icon [ ] and slide on the
screen to take off.
GPS
Retract Landing Gears
9
VOL
Raise the landing gear control using
12.6V
FSK
the landing gear control switch on the
ST16S.
FSK
WiFi
WIFI
CHA
POS
Landing
CHA
POS
Step 1)
Lower the landing gear
using the same control as used for
00 : 35 : 25
retracting landing gear.
NOTICE:
Lower the landing gear at
least 12' above the landing area.
Step 2)
Slowly lower the left-hand
stick below the center position,
TYPHOON H PLUS will descend
slowly and land. After TYPHOON H
PLUS lands, the motors will stop after
2 seconds without any operation.
Take Off
300M
125km/h
Roll 120˚
Pitch 0˚
D/R 0˚
System Setting Channel Setting Model Se