Advertisement
These instructions should be read carefully and left with the user of the product for future reference.
Before use please Inspect the product including its cable and plug for any signs of damage. If the product
is damaged, DO NOT use it, and contact your supplier immediately.
OPERATING INSTRUCTIONS
1. Place the humidifier on a flat surface, about
60cm away from the floor and 10cm away
from the wall. We recommend you do not
place the humidifier directly on to wooden
furniture.
2. Remove the water tank by lifting the moisture
outlet, holding the handle and lifting up.
(See figure 1 )
3. Remove the tank cap from the bottom of the
tank by turning clockwise. Fill the water tank
with cool, fresh water. Do not fill with warm
water as this can cause the unit to leak.
4. When the tank is full replace the tank cap and
place the tank back onto the base. The water
will begin to flow from the tank into the base.
5. Plug the power cord into the electrical outlet.
6. Press the control knob to turn the humidifier
on. Turning the control knob clockwise will
increase the amount of mist produced.
7. In standard operating mode the indicator light
will be green, if the light turns red this means
that the unit needs more water.
(see steps 1-4 for refilling the tank)
At time of going to press, the average cost of electricity is £0.13 per unit (kilowatt-hour). The amount
you are being charged will be shown on your electricity bill. At this cost, the EH1415 will cost 7.4p per
day to run.
When used in an office environment, we recommend that this product should be safety-tested yearly by
a qualified electrician (PAT Tested).
We recommend that it is PAT tested regularly when used in a domestic environment.
Domestic wiring must be tested periodically by a qualified electrician at least once every 10 years or at
every change of occupancy.
For office and retail premises, and buildings such as village halls, the wiring must be inspected at least
once every 5 years.
It is recommended that all building be fitted with smoke alarms (it is mandatory for new buildings).
IMPORTANT
Installer and Users please note:
OPERATING COSTS
PAT TESTING
GENERAL SAFETY REQUIREMENTS
Moisture Outlet
Water Tank
Tank Cap
Gasket
Tank Cap
Main Body
Indicator Light
2
Control
Knob
Ver 1 01/2015
Handle
Transducer
fig. 1
Advertisement
