Page 1
This product is intended for indoor use only. We recommend using a qualified trades person for installation. Use an assistant or lifting equipment to lift and position products. For support, please call: +44 (0)1865 767676 or email: sales@unicol.com...
01865 767676 sales@unicol.com www.unicol.com TOOLS REQUIRED INSTALLERS REQUIRED Pozi Head Screwdriver 4mm & 5mm Allen Keys 19mm Spanner 17mm Spanner Rubber Mallet COMPONENTS *bases may vary from model to model *masts may vary from model to model DESCRIPTION Rhobus Mast (inc. cabinet door)
Page 3
STEP 2 Connect base to mast as shown (4 fixings for Unlock and lift out rear door. Remove upper rear RH100 and 6 for HD versions). panel by unscrewing 4x M6 screws. For RH200, please continue on page 6. For a stand version, insert the plastic feet. For a...
Page 4
01865 767676 sales@unicol.com www.unicol.com STEP 5 STEP 6 Locate the mounting holes on the back of your Line the screen and arms up with the secured back screen. Line the two mounting arms up and using plate and offer it up at a slight angle - allowing the...
Page 5
01865 767676 sales@unicol.com www.unicol.com BOLT DOWN STEP 2a STEP 1a With mast laying flat on a table (as shown above) Once secure, stand the stand upright and place pick up the base and offer the base to the mast. on a flat, stable surface. Mark position of holes, as Ensure fixing holes are aligned and then secure.
01865 767676 sales@unicol.com www.unicol.com TWIN SCREEN STEP 3 STEP 3a Place 2x screws in the bottom two rivnuts of the Feed cables for screen through hole in backplate span bar plate and slot into chosen keyholes in and front of mast, down through cable access and mast.