Power Supply 380-415V 3N; Power Supply 220 - 230V 3; Power Supply 220 - 230V 1N; Safety Devices - Nordcap ZANUSSI EXLIG Installation Manual

• Make sure the machine power supply voltage specified on
the rating plate matches the mains voltage.
• Make sure the system power supply is arranged and able to
take the actual current load and that it is executed in a
workmanlike manner according to the regulations in force in
the country of use.
• The earth wire from the terminal board side must be longer
(max 20 mm) than the phase wires.
• Connect the power cable earth wire to an efficient earth.
The equipment must also be included in an equipotential
system, whose connection is made by means of screw EQ
(see the installation diagram) indicated by the symbol
The equipotential wire must have a section of at least 10
mm 2 .
E.7.1

Power supply 380-415V 3N~

E.7.2

Power supply 220 - 230V 3

E.7.3

Power supply 220 - 230V 1N

E.8

Safety devices

• An automatic-reset overload protector incorporated in the
electric pump windings cuts off the power to the pump in
case of faulty operation.
• A device prevents the booster water from returning back
into the system in the event of a water supply system fault.
• An overflow pipe connected to the discharge ensures a
constant water level in the tank.
• If the water level in the tank is too high, the drain pump (if
present) automatically activates to empty out the excess
water.
IMPORTANT
The Manufacturer declines any liability if the
accident-prevention regulations are not respected.
E.9 Detergent/rinse aid dispensers and
prearrangements
NOTE!
If the machine is connected to a water softener
and/or a reverse osmosis system, contact the
detergent supplier for a specific product.
CAUTION
The peristaltic dispensers (detergent and
rinse-aid) and the tube inside the rinse-aid
dispenser require periodical maintenance
.
(at least once or twice a year) or after
prolonged machine idle periods.
NOTE!
If the peristaltic dispensers are installed in the
machine, the dosage of detergent/rinse aid is done
automatically according to the desired concentra-
tion. The concentration of detergent/rinse aid
depends on the type of product used and the
hardness of the supply water (check the character-
istics on the product label).
Dishwasher with incorporated peristaltic liquid detergent
dispenser
1. The detergent pump dispenses about 0.82 g/s of
detergent.
Dispenser operation time can be modified according to the
instructions given in the next paragraph (H BASIC
SETUP). Insert the hose supplied in the detergent
container.
Dishwashers with incorporated peristaltic rinse-aid
dispenser pump
2. The rinse-aid pump dispenses about 0.12 g/s of rinse-aid.
Dispenser operating time may be changed, following the
instructions given in the next paragraph (H BASIC
SETUP). Insert the hose supplied in the rinse-aid
container.
ENGLISH
15