Safety Instructions; Batteries Charging - BST PORT4BT Instruction Manual

PORT4BT / PORT4BT-H
4)

SAFETY INSTRUCTIONS

Read all safety instructions before operating PORT4BT / PORT4BT-H
Install equipment as follow condition.
- Install in a flat place, not bending or curved.
- Do not install near water and moisture.
- Place power amplifier away from heat source, such as radiators or other heat source.
Keep in mind the following when connecting amplifiers
- Read the owner manual before connecting the amplifier
- Connect each connection of the amplifier perfectly. If not, it maybe cause hum, damage, electric shock in case of misconnection.
- To prevent electric shocks, do not open top cover.
- Connect the power cord with safety after check of AC power
5)

BATTERIES CHARGING

- Connect the AC cable in the AC /DC adapter then connect it to DC input on PORT4BT. The batteries leds lights on green showing a
good operating of the charge system. If the led lights in red, the batteries are empty.
- The charge automatically stops when batteries are full charged. Stay the speaker in charge during 4 to 6 hours or a good charge. For
a full charge, keep it in charge during 10 hours..
NOTE : Even if you do not often use the PORT4BT, you must charge batteries at least once a month, otherwise you may destroy
the batteries
6) SPECFICATIONS
- Frequencies band : VHF
- Stability : +/- 0.005%.
- Modulation : +/-20KHz
- Frequency response : 80Hz – 18KHz (+/-3dB)
Sensitivity : 10dB
-
- Power : 40W (max ) / 25W ( RMS )
Charging time : 8-10 heures max
-
- Operating time : 2-4 heures max
Wireless operating range : 35m max
-
- Dimensions : 155x280x170mm
- Weight : 3Kg
Handheld mic :
Built-in antenna
-
- Batteries : 2x 1.5V AA
Operating time : 8 hours max
-
- RF power : 10mW
Belt transmitter :
- Mic impedance : 470Kohms
Batteries : 2x 1.5V AA
-
- Operating time : 10 heures max
© Copyright LOTRONIC 2015
BATTERIES PLACE
Insert two 1.5V batteries ( pay attention to the polarity). The operating time is about
10 hours
WWW.BSTDJ.COM
Page 8