Power Switch - BST PORT4BT Instruction Manual

PORT4BT / PORT4BT-H
2) HANDHELD WIRELESS MIC DESCRIPTION
3) BELT TRANSMITTER DESCRIPTION
1. VOLUME CONTROL
2. ON / OFF LED
When you turn on the microphone, the light should lights on. If the indicator stay off, that means that the batteries are too low. You must to replace its
3. POWER SWITCH
Use to switch the belt transmitter on or off
4. MIC INPUT
Connect your headset to this input. Note: screw jack socket. It is necessary to hold the jack connector and then screw it
5. TIE MIC CONNECTOR
Insert the connector in mic input of the belt transmitter and then screw it
6‐ HEADSET MIC CONNECTOR
Insert the connector in mic input of the belt transmitter and then screw it
© Copyright LOTRONIC 2015
1. CARTRIDGE
2. ON / OFF LED
When you turn on the microphone, the light should lights on. If the indicator stay off, this
means that the batteries are too low. You must to change for new ones

3. POWER SWITCH

Use to switch the handheld mic on or off
BATTERIES PLACE
Insert two 1.5V batteries ( pay attention to the polarity). The operating time is about
8 hours
WWW.BSTDJ.COM
Page 7