Advertisement
By pressing the relative button of the desired program (see table) it will
light up the relative pilot light to confirm that the operation occurred and
on the DISPLAY a program duration forecast will appear ("h.mm").
START PROGRAM
At this point, in order to start the machine, it is only enough to press the
START/PAUSE
start to flash and confirmation "beep" is heard. From this moment the cycle
duration on the DISPLAY starts to decrease.
This phase, that updates itself during the cycle, is "indicative" since it is
influenced by the washing conditions such as dishwasher type and
quantity, entry temperature etc. For this reason it is normal to see the
updating during a program (increment and decrease of minutes) specially
in the passage from one phase to the other (for example, from washing to
rinse).
Program progress is indicated by the program phases that show the status
of the current cycle.
The current phase flashes, while the next washing phases lights stay on.
At the end of each phase, the signal will turn off.
N.B.: when a program which does not need the prewash phase is
selected, the prewash signal stays off.
END PROGRAM
At the end of the program the DISPLAY shows "Time to end". By
pressing one of the program buttons, "Time to end" turns off and the
washing machine is ready to start a new cycle.
8
User instructions
for some seconds until the symbol START/PAUSE
Prewash
Rinse
smeg-tr.com
Wash
Drying
Advertisement
