BorMann HOME DS1000 Owner's Manual page 5

7. SPEED CHANGE: Press and hold 【FUNCTION】key and 【ZERO】 key for three seconds and after the instrument indicates "----
-X", the speed change will be done, X is for the speed mode: 1-quickest speed,3-slowest speed
8. UNIT CHANGE: By pressing and holding 【FUNCTION】key, unit g and kg (or Lb. and kg) can be changed each other
9. AUTOMATIC OFF: The scale turns off automatically when [LobAt] is seen for 10 seconds. When the voltage is not sufficient,
[LobAt] is seen every 1 minute and then the scale turns off after 8 times when weighing.
Attentions
For battery: When the scale is turned on and in process of the weighing function, the display [LobAt] is seen in the window, it
shows that the power in the battery is not enough and it is necessary to be charged immediately by turning off the scale.
Otherwise, the life span of the battery will become shorter.
How to charge: When the indicating lamp in the charger is lit, the battery is recharged (The recharging is quicker in case the scale
is turned off). More than 12 hours are needed when recharged. If the scale is not be used for a long time, the scale should be
recharged every two months.
Note: 1) It is suggested to charge more three hours when the light of the charger is turned from the red to the green
2) The user must use the charger supplied with the scale and must not use other charger that may damage the scale.
3．Easy test of the weighing performance: Before used every day, the same poise or same object putting on the scale should be
compared every day before the scale is used. If there is something wrong, the scale cannot be used and should be repaired.
4．The scale cannot be used together with the high power equipment by sharing the same power supply.
How to calibrate
When the scale is found incorrect, please calibrate the scale in the following procedures.
1. Preheat the scale for 5 minutes after the scale is turned on
2. Turn on the scale again and return to "0"
3. put 1/3 of the full capacity weight by poise ( for example, for 3kg scale, put 1kg poise)
4. After stable, press and hold [CALIBRATION] + [ZERO] + [TARE] for three seconds, you can see the weight of the poise you
loaded and the calibration is over.
Failure and Solution
1. [FULL ]——Overload. You should move the object on the scale and otherwise the scale may damage the load cell
2．[LLLLL]—— The zero position of the load cell is negative. Please check the instrument and load cell
3．[LobAt]——The voltage of the battery is too low and it is necessary to charge the battery
4．[- - - - - -]——The parameter already calibrated is lost and the scale is locked. It is necessary to calibrate the scale once again
5.[ Err8 ]――The weight of the load is too light when being calibrated
IMPORTANT: The battery and the load cell in the scale are not included in the warranty (The overload is strictly prohibited). The user
is required to take a good care of them.
5
www.BormannTools.com