System Build 4067335COM Manual page 12

STEP 6
IMPORTANT: THIS UNIT MUST BE SECURED TO A WALL TO HELP PREVENT TIPOVER. FOLLOW
THESE INSTRUCTIONS TO INSTALL THE ANTI‐TIPPING SAFETY BRACKET PROVIDED WITH THIS
PRODUCT.
WARNING
Serious or fatal crushing injuries can
occur from furniture tipover. To
prevent tipover:
• Install tipover restraint provided
• Place heaviest items in the lowest
drawers
• Unless specifically designed to
accommodate, do not set TVs or
other heavy objects on the top
of this product
• Never allow children to climb or
hang on drawers, doors, or shelves
• Never open more than one
drawer
at a time
Use of tipover restraints may only
reduce, but not eliminate the risk of
tipover
Option 1: Attachment into a wall stud (preferred method)
Using a stud finder, locate a stud in the wall. Place your unit against the wall, with the safety bracket (10a) aligned at this
location. To make driving the screw easier, you can drill a 1/8" diameter pilot hole (3mm) through the safety bracket (10a) into
the stud. Drive the screw (10c) through the safety bracket (10a) into the wall stud. Tighten the screw (10b) that was not fully
tightened in step 3.
Option 2: Attachment into drywall
Locate your unit where desired against a wall and mark the wall through the safety bracket (10a), then move your unit aside.
3
Drill a " diameter hole (5mm) in the wallboard. Tap the wall anchor (10d) into hole until it is flush. Move your unit into
16
location and fasten the wall bracket (10a) to the wall anchor (10d) with the screw (10c). Tighten the screw (10b) that was not
fully tightened in step 3.
systembuild.com
10c
10d
(x1)
#A84050
For Masonry, Concrete, or other wall materials:
Consult your local hardware store for appropriate
anchors to securely attach the safety bracket.
option 2
10c
12
hole
agujero
trou
10d
option 1
wallboard
muro
mur
stud
montante
planche
You
Tube