Advertisement
General Description and Basic Use Instructions
Included with your Rebel Xtreme semi-auto should be the
following items:
• Rebel Xtreme Semi-Auto
• Barrel
• Low Pressure Chamber
• Packet with o-rings, velocity thumb
screw, and allen wrench
• Separate Allen wrench
The 32 Degrees Rebel Xtreme is almost ready to use out
of the box. All that is needed is a C02 tank, paintballs,
and a feeder, and then you are ready use your marker.
First screw in your barrel (hand tight). Now that your
barrel is in, insert the barrel plug into the front of the
barrel. With your barrel plug in, you are ready to work on
your marker. Next push the safety in the "safe" position
and attach your feeder elbow and feeder to the power
feed tube. Turn the power feed plug so that it does not
allow paintballs to enter the chamber. Screw the low
pressure chamber into the front end of the marker, just
below the barrel. Now that you have everything
connected you are ready to gas up the gun. Before you
gas up the marker you should always wear paintball
approved goggles.
Getting Started
maintenance
Now that the goggles are on make sure your marker is in
the cocked position. Install the C02 tank and your Rebel
Xtreme is ready to fire. Make sure you chronograph your
marker before you use it. Like any other paint marker,
maintenance is the key to keeping the Rebel Xtreme
shooting consistently. This chapter is a basic overview of
what it takes to keep the Rebel functioning properly.
Lubrication: To keep your Rebel Xtreme internal
components operating smoothly, place about four
drops of oil in your gun's C02 adapter and dry fire the
gun (after removing the barrel). This will spread the
oil throughout the gun. After cleaning your Rebel Xtreme
internally, lube the hammer/push strut assembly as
well--be careful not to over-oil this area.
Warning: Some petroleum based oils can damage
your gun's o-rings. Use only oil manufactured
specifically for paintball markers.If you expect any degree
of consistency from your Rebel Xtreme, you must keep it
clean internally and externally. The two external areas
you'll need to be the most careful with are the power
feed/feed tube and the barrel. If you break a ball in the
barrel, you will lose most of your accuracy until you clean
it completely. On the field, remove the barrel and run a
pull-through squeegee through it. For a more complete
cleaning (off the field) you'll need to clean the barrel
with warm water or barrel cleaner/treatment and
squeegee it until it is dry. A pull-through squeegee can
also be used to clean the power feed once the plug
is removed.
Advertisement
