Advertisement
Step 2:Install the rear bumper and gearbox
Tools needed: Wrenches & Screwdriver
& Socket
A. Remove the two pivot bolts from
both sides of the gearbox.
C. Insert the two pivot bolts through
the aligned holes and install the nuts
on each bolt. Using the supplied
tools, tighten each nut onto the pivot
bolts. Tighten the bolt and nut
simultaneously.
Pivot
B. Rotate the gearbox to its down position.
Place the right and left shocks into the
gap between the posts where the pivot
bolts were removed and align the holes.
Combine socket
and screwdriver as
shown right.
Fig. A
Advertisement
