Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Steeper S-Charge
Summary of Contents for Steeper S-Charge
- Page 1 S-Charge System Battery System with Display and Magnetic Charger User Manual...
-
Page 2: Table Of Contents
Your S-Charge System Important Information The S-Charge Display Troubleshooting Features and Benefits Disposal Compatibility Warranty Starting the S-Charge System Environmental Operational Conditions Waking up the S-Charge Test Certification Low Battery Quality Assurance Charging the Prosthesis Symbols Used on Product &... -
Page 3: Your S-Charge System
The S-Charge Display Your S-Charge System The S-Charge System is an easy to control charging system that is fitted into your prosthesis to allow you to easily activate, deactivate, charge and monitor the power status on your prosthesis. Your S-Charge System is operated using a standby button, a visual display and a magnetic wall charger. -
Page 4: Features And Benefits
Features and Benefits Compatibility • Fully charges the prosthesis within five hours. Please only use your S-Charge System with the prosthesis provided by your prosthetist. • Visual display of the power status. The S-Charge System is only compatible with the •... -
Page 5: Starting The S-Charge System
Note: The S-Charge System may require a short amount of charging time before initial start-up. 1. To activate the S-Charge System, hold down See page 11 for instructions on how to do this. the standby button (C) for 1 second. -
Page 6: Low Battery
1. Connect the display will flash the below screen, on the magnetic plug press of the button, if the system is active: to the magnetic charging port (A) of the S-Charge System Please note: If pulled, the magnetic charger Note: If the battery level then falls below 10%, will auto release. -
Page 7: Putting The Prosthesis On Standby
3. A short press of the standby button will display the standby symbol when the system is deactivated. S-Charge User Guide... - Page 8 Care and Cleaning 1. If there is a fault detected during charging, the display will show as follows: • It is important to inspect your S-Charge System regularly to ensure early detection of any potential problems. • The S-Charge System has been designed to require minimum maintenance, 2.
- Page 9 S-Charge System charger supplied by your clinician. • The S-Charge System is not waterproof, so • If the S-Charge System has been in storage, please moisture must not enter the system. If liquid does leave in an ambient temperature (20° C) for a enter the system, it must not be operated and minimum of 2 hours before use.
-
Page 10: Troubleshooting
15 minutes. try again. If the problem persists, please contact your prosthetist for further assistance. 3. If the problem persists, return the S-Charge System and the wall charger to your clinician for Please do not attempt to open or modify any further assessment. -
Page 11: Disposal
If the problem persists, return general household waste. the S-Charge System and the wall charger to your clinician for further assessment. For safe disposal of this Device please contact the Clinic/Hospital where this... -
Page 12: Warranty
0°C (+32°F) to Charging 45° (113°F) The warranty period for the S-Charge is 12 months. Pressure range 700-1060 hPA The designed service life of the S-Charge System is 2 years. Other than the guidance outlined in ‘Care 65 ±... -
Page 13: Test Certification
Test Certification Quality Assurance Steeper/SteeperUSA operate a quality management The S-Charge System and its associated components listed within this document have been tested system that fully complies with the requirements of and certified to the following standards and BS EN ISO 13485:2016. This certifies that Steeper/... - Page 14 Directive RoHS 2015/863/EU. and components are subject to a policy of continuous reappraisal. The company, therefore, This S-Charge is an accessory for Class I Medical reserves the right to introduce changes and Devices which meets the general safety and withdraw products without notice. For the most performance requirements in MDR 2017/745 Annex I.
-
Page 15: Symbols Used On Product
Single Patient - Multiple ISO/DIS 15223- use Symbol 1:2020(E) DRAFT Indicates the ISO 15223- 1:2016 Reference no. manufacturer’s batch Reference no. 5.4.12. (ISO code so that the batch 5.1.5. (ISO 7000- 7000-3706) or lot can be identified. 2492) S-Charge User Guide... - Page 16 Packaging is covered by FSC Certification ofor recycle this the Forest Stewardship product in accordance Council assurance with local laws or that it is made with, or regulations that apply. contains, forest-based materials from FSC certified forests or reclaimed sources. S-Charge User Guide...
- Page 17 Steeper Group, Unit 3, Stourton Link Intermezzo Drive, Leeds, LS10 1DF, United Kingdom Tel: +44 (0) 113 270 4841 customerservices@steepergroup.com www.steepergroup.com Steeper USA, 8666 Huebner Road, Suite 112, San Antonio, TX 78240, USA Tel: 210 481 4126 sales@steeperusa.com www.steeperusa.com KSA Authorised Representative...
Need help?
Do you have a question about the S-Charge and is the answer not in the manual?
Questions and answers