Subscribe to Our Youtube Channel
Related Manuals for CONQUEST Carbon Edge 28TE
Summary of Contents for CONQUEST Carbon Edge 28TE
- Page 1 CONQUEST CARBON EDGE 28TE FLOOR SCRUBBER OPERATOR MANUAL T: 1800 826 789 E: service@conquestequipment.com.au E: parts@conquestequipment.com.au W: conquestequipment.com.au...
- Page 2 Scan QR code to access your Carbon 28TE Floor Scrubber Operator video...
- Page 3 Tornado Edge Scrubber All claims for warranty are subject to inspection and approval on receipt of the faulty product by Conquest Warranty Department. A replacement product will not be forwarded or repairs will not be made until inspection has been made and warranty has been approved.
- Page 4 Fit blue cleaning pad to scrub deck. Ensure pad is in good condition and more than 12mm thick. Always use genuine Conquest Tomcat blue pads (EDGE-4052) Check squeegee is clean and squeegee blades are in good condition. Rotate if required –report...
- Page 5 Getting to know the Conquest Carbon Edge Let’s start with a quick tour of your Conquest Carbon Edge floor scrubber, to help you become familiar with the technology and terminology referenced throughout this video.
- Page 6 Step one, power up your Conquest Carbon Edge scrubbing machine by turning the key in the ignition to the “on” position. The LCD display will illuminate to show a battery indicator, a water setting indicator, and a brush pressure indicator. You will also see the brush operation, water flow and vacuum operation symbols indicating that all systems are activated.
- Page 7 Weekly battery maintenance Battery maintenance Once a week, you should perform maintenance on the batteries that power your Conquest Carbon Edge scrubbing machine. Ensure that the batteries are fully charged before performing battery maintenance, and always use protective gloves and safety glasses to minimise the risk of injury when working with lead acid batteries.
-
Page 8: Introduction
INTRODUCTION This manual is furnished with each new machine. This manual will allow the Operator to get the best performance out of your RPS manufactured Scrubber-Drier, Sweeper, Burnisher, or Orbital Scrubber. Read this manual thoroughly before operating or servicing the machine. This machine will provide excellent performance, but the best results will be obtained at the most minimum costs if: •... -
Page 9: Table Of Contents
TABLE OF CONTENTS Introduction Locate Serial Number Table Of Contents Safety Messages Safety Labels DANGER LCD Screen Operation Controls Battery Setup Remove Squeegee Adjust Squeegee Remove From Battery Charger Transportation - Forward Transportation - Reverse Fill Solution Tank Operation - Scrubbing WASTE WATER DRAINS ONLY! Draining Recovery Tank WASTE WATER DRAINS ONLY! -
Page 10: Safety Messages
SAFETY MESSAGES You will see four kinds of safety reminders in this manual: DANGER WARNING DANGER indicates a hazardous situation which, if not WARNING indicates a potentially hazardous situation avoided, will result in death or serious injury. which, if not avoided, could result in death or serious injury. NOTICE CAUTION NOTICE indicates information considered important, but... - Page 11 WARNING WARNING The Batteries in this machine produce hazardous Dress safely. Do not wear rings or metal wrist watches voltage which can cause electrical shock, burns and/ when servicing this machine, as they can cause an or electrocution. Always disconnect Batteries before electrical short circuit which can cause serious burns.
-
Page 12: Safety Labels
DANGER SAFETY LABELS Read and obey all Safety Labels on your CARBON Floor Scrubber. If you have questions about these labels, ask your supervisor. These images indicate where on the CARBON Safety Labels are located. If ever the labels become illegible, worn off, or torn, promptly report it to your supervisor and replace it. -
Page 13: Lcd Screen
LCD SCREEN SCREEN #1 (OPERATOR) SCREEN #2 (MAINTENANCE) SCREEN #3 (WITH ERROR CODE) ** USE GREEN MENU SELECTION BUTTON ON CONTROL PANEL TO CHANGE SCREENS ** 1. BATTERY LEVEL INDICATOR - Indicates the energy level remaining in the Batteries (Shown on all menu displays) 2. -
Page 14: Operation Controls
OPERATION CONTROLS TC-CARBON-OP-EN... -
Page 15: Battery Setup
BATTERY SETUP NOTICE Batteries are a possible environmental hazard. Consult your Battery supplier for safe disposal methods. NOTICE Orientation of Batteries is critical for cables to reach. Ensure proper torque values when installing batteries. (Between 8 - 12 ft/lbs) 24 VOLTS TC-CARBON-OP-EN... -
Page 16: Remove Squeegee
REMOVE SQUEEGEE TC-CARBON-OP-EN... -
Page 17: Adjust Squeegee
ADJUST SQUEEGEE TC-CARBON-OP-EN... -
Page 18: Transportation - Forward
TRANSPORTATION - FORWARD ½ SPEED TC-CARBON-OP-EN... -
Page 19: Transportation - Reverse
TRANSPORTATION - REVERSE TC-CARBON-OP-EN... -
Page 20: Fill Solution Tank
FILL SOLUTION TANK < 21 Gal. ( 79.5 l ) < 21 Gal. ( 79.5 l ) < 130°F / 54°C < 130°F / 54°C DANGER CAUTION EXPLOSION RISK! Flammable materials can cause an TO AVOID DAMAGE TO THIS MACHINE: •... -
Page 21: Operation - Scrubbing
OPERATION - SCRUBBING ½ SPEED TC-CARBON-OP-EN... -
Page 22: Draining Recovery Tank
WASTE WATER DRAINS ONLY! DRAINING RECOVERY TANK WASTE WATER DRAINS ONLY! TC-CARBON-OP-EN... -
Page 23: Draining Solution Tank
WASTE WATER DRAINS ONLY! DRAINING SOLUTION TANK WASTE WATER DRAINS ONLY! TC-CARBON-OP-EN... -
Page 24: Flushing Recovery Tank
FLUSHING RECOVERY TANK TC-CARBON-OP-EN... -
Page 25: Clean Drain Saver
CLEAN DRAIN SAVER TC-CARBON-OP-EN... -
Page 26: Clean Vac Box System
CLEAN VAC BOX SYSTEM TC-CARBON-OP-EN... -
Page 27: Remove Edge Pads
REMOVE EDGE PADS Grip Face Spacer Prep Pad TC-CARBON-OP-EN... -
Page 28: Battery Chargers
BATTERY CHARGERS Onboard / AGM / International Chargers: AC Power: 80-270VAC / 50-60Hz DC Power OUT: 24VDC / 27A Please refer to OEM Charger Operating Instructions for more information. COMMON WEAR PARTS EDGE PADS AND SQUEEGEE DESCRIPTION 28''×14'' SCRUBDECK White Pad EDGE-4054 Red Pad EDGE-4053...
Need help?
Do you have a question about the Carbon Edge 28TE and is the answer not in the manual?
Questions and answers