Nokia 3555 Service Manual page 106

• Send the file to Nokia by e-mail. Use the following addresses depending on your location:
• APAC: sydney.service@nokia.com
• CHINA: repair.ams@nokia.com
• E&A: salo.repair@nokia.com
• AMERICAS: fls1.usa@nokia.com
• When you receive a reply from Nokia, carry out certificate restoring.
• Tune the phone completely.
Note: SX-4 smart card is needed.
• If the phone resets after certificate restoring, reflash the phone again.
Required equipment and setup:
Phoenix service software v 2007.04 or newer.
•
• The latest phone model specific
• PKD-1 dongle
• SX-4 smart card (Enables BB5 testing and tuning features)
• External smart card reader
Note: FPS-10 has an integrated smart card reader.
• Activated FPS-10 flash prommer
• Flash update package 03.18.004 or newer for FPS-10 flash prommers
• CU-4 control unit
• USB cable from PC USB Port to CU-4 control unit
• Phone model specific adapter for CU-4 control unit
• PCS-1 cable to power CU-4 from external power supply
• XCS-4 modular cable between flash prommer and CU-4
Note: CU-4 must be supplied with +12 V from an external power supply in all steps of certificate
restoring.
Steps
1. Program the phone software.
Phoenix and login. Make sure the connection has been managed correctly for FPS-10.
i Start
ii Update the phone MCU software to the latest available version.
If the new flash is empty and the phone cannot communicate with
iii Choose the product manually from File→Open Product , and click OK.
Wait for the phone type designator (e.g. "RM-1" ) to be displayed in the status bar.
iv Go to Flashing→Firmware Update and wait until
following picture.
Page 3 –58
Phoenix data package.
COMPANY CONFIDENTIAL
Copyright © 2007 Nokia. All rights reserved.
BB Troubleshooting and Manual Tuning Guide
Phoenix , reflash the phone.
Phoenix reads the product data as shown in the
RM-257; RM-270; RM-277
Issue 1