&Tradition FLOWERPOT GARDEN VP5 Assembly Instructions

FLOWERPOT GARDEN VP5

by Verner Panton

ASSEMBLY

INSTRUCTIONS

andtradition.com

Congratulations on choosing this original

FlowerPot Garden lamp, designed in

1969 by Verner Panton. We hope you will

enjoy using this lamp and follow these

instructions to ensure correct installation.

If you have any questions or comments,

please do not hesitate to contact us by

mail on: info@andtradition.dk

Table of Contents

Need help?

Do you have a question about the FLOWERPOT GARDEN VP5 and is the answer not in the manual?

Page 1 FLOWERPOT GARDEN VP5 by Verner Panton ASSEMBLY Congratulations on choosing this original FlowerPot Garden lamp, designed in INSTRUCTIONS 1969 by Verner Panton. We hope you will enjoy using this lamp and follow these instructions to ensure correct installation. If you have any questions or comments, please do not hesitate to contact us by andtradition.com...
Page 2 IMPORTANT: DO NOT attempt installation of this lamp yourself. This lamp must only be installed by a professional authorised electrician. This lamp requires correct insulation and connection to the mains power supply. Please read these instructions carefully and retain them for future reference to ensure that the lamp is correctly assembled, should it be moved or sold.
Page 3 A - Ensure that the lamp is standing uprightat 90 degrees from the ground. B - The Lamp must be installed so that the anchor is completely burried and covered by earth. C - The cable must be covered by a layer of earth of at least 5 cm until the point where it is linked to the house mains power supply.
Page 4 Maximum 60 W. Tungsten E27 bulb. Maximum 12 W. Low Energy E27 bulb. KONGEVEJEN 2. DK-3480 FREDENSBORG. T. +45 39200233 F.+45 39200256 INFO@ANDTRADITION.DK WWW.ANDTRADITION.COM...