Check The Malfunction And Repair; Technical Characteristics - Orbegozo HU 2013 Instruction Manual

HU 2013
2. Wipe the body of the appliance off with a soft damp cloth. If
necessary use a little washing-up liquid.
3. Rinse the water tank with clean water after each use. To dry for
storage, wipe with a soft clean cloth.
4. Do not use detergents to clean any part of the unit that normally
contains water. Detergents can interfere with the performance of the
unit.
5. Do not immerse the humidifier in water or any other liquid.
6. Do not use harsh or abrasive cleaning agents or solvents.

CHECK THE MALFUNCTION AND REPAIR

If your humidifier can't work, please ask the service department to
repair:
MALFUNCTION
1. Power indicator
can't work and with no
wind and mist
2.Power indicator
illuminate, the unit
with wind but no mist
3.Smelly mist
4.Power indicator
illuminate, the unit
with no wind and mist
5.Little mist comes out
of the nozzle
6.Abnormal noise

TECHNICAL CHARACTERISTICS

220V ~ 50/60Hz
§
§
Power 18W
§
Mist volume 150-180 ml/h
§
Water tank capacity 1.3L
CAUSATION
Didn't connect the
power supply
Didn't turn on the
humidifier
No water in the water
tank
Mist adjusting is too
low
Floater don't float
enough
New humidifier
Dirty water or long-
time to store water in
water tank
Too much water in the
base flume
Dirty ultrasonic
transducer
Dirty water or long-
time to store water in
water tank
Caused by little water
in water tank.
Resonance from table-
board
RESOLVE METHODS
Connect the humidifier
from the power supply
Switch on the unit
Fill water in water
tank
Increase the adjustment
Fill water in water
tank
Open water tank, put it
in shadow for 12 hours.
Clean the water tank,
fill clean water in.
Empty the flume, then
close the cap of water
tank.
Clean the transducer
Clean the water tank,
fill clean water in.
Fill water in water
tank.
Place on a stable level
surface.
15