REMOTE CONTROL
How to load the lithium battery
numerical sequence shown in the diagram.
holder.
Place the battery with the side bearing the @
mark facing up.
When inserting the battery holder, take care
not to touch any of the buttons on the remote
controller.
The lithium battery will wear out faster if a but-
ton is pressed when the holder is inserted.
The remote controller will cease to operate when the battery has worn out. Always
use a CR2025(3V) lithium battery as the replacement.
Note:
Keep lithium batteries out of the reach of small children.
l
Do not use metal tweezers or anything similar to hold the battery since this may
l
cause short-circuiting.
since this may cause them to explode. Dispose of worn-out batteries as incom-
bustible waste.
Remote controller unit
Range of remote control operation
Up to about 4 meters linearly at an angle of 15" in both the horizontal and verti~l
directions
Note:
Do not expose the controller unit fo direct sunlight for long.
l
Point the fransmitter of remote controller unit towards the remote controller sensor
l
of the main unit.
INSTALLATION
Remote
controller
(Reverse side)
Installation of the display unit:
Peel off the removable seal on the top of the
display unit and install it in a location that
will not obstruct driving.
Installation of the FM Modulator/Ground Isolator:
Install the FM Modulator/Ground Isolator to
the floor or other surface with the included
tapping screws (M3 x 12).
ERROR DISPLAYS
q
If the event of a CD changer malfunction, one of the errors described below will be
displayed.
I
Error Displays
Cause
Error display
I.... . * . : : :
I
Disc change malfunction.
I.... I...1
Disc loaded upside down.
I....
. . .
I.... !.A I
Dirty disc.
Too high temperature to play.
Magazine has not been installed.
No discs loaded inside magazine.
. . . . .
No discs loaded into magazine
. . ..I 8.. . . . mm*
Need help?
Do you have a question about the CDM-100R and is the answer not in the manual?
Questions and answers