Cleaning And Replacing; The Air Filter - Panasonic PT-AE100U Operating Instructions Manual

Indicator
Illuminated (red)
display
It is nearly time to
replace the lamp
Problem
unit.
B Does "REPLACE
LAMP" appear on
Possible
the screen after
cause
the projector is
turned on?
B This occurs when
the operation time
for the lamp unit is
nearing 1800
hours. (when
LAMP POWER
has been set to
Remedy
"HIGH") Ask your
dealer or an
Authorised
Service Center to
replace the lamp
unit.
NOTE:
B Be sure to turn off the MAIN POWER switch by following the procedure
given in "Turning off the power" on page 23 before carrying out any of the
procedures in the "Remedy" column.
B If the main power turns off after the TEMP indicator starts flashing, it
means that an abnormality has occurred. Please contact an Authorised
Service Center so that the necessary repairs can be made.
40
All manuals and user guides at all-guides.com
LAMP indicator
Flashing (red)
An abnormality has been detected in the lamp
circuit.
B The power may B There may be an
have been turned
on straight away
after it was turned
off.
B Wait for a while B Turn off the MAIN
until the lamp unit
cools down before
turning the power
back on again.
abnormality in the
lamp circuit.
POWER switch by
following the
procedure given
on page 23, and
then contact an
Authorised
Service Center.
Cleaning and r
If the air filter becomes clogge
projector will rise, the TEMP in
turn off. The air filter should
depending on the location whe
Cleaning procedure
# Turn off the MAIN POWER
switch and disconnect the
power cord plug from the
outlet.
Turn off the MAIN POWER
according to the procedure
in "Turning off the power" on
page 23 before disconnectin
plug from the wall outlet.
$ Gently turn the projector
upside down.
NOTE:
B Place the projector on top o
soft cloth so that it will not
become scratched.
% Remove the air filter.
Put your fingernails under th
filter and pull the air filter ou
the projector.
Air filter