Bosch BEA 750 Assembly Instructions Manual page 7

1.3 Carrying out recovery
!
All data and applications on the hard disk will be
erased during the installation!
!
Make sure the voltage supply is not interrupted du-
ring the installation process.
i
A USB keyboard is necessary for the recovery.
1. Turn off the BEA 750 via the power switch on the
back of the unit.
2. Connect the USB stick to BEA 750.
3. Connect keyboard to the BEA 750.
4. Turn on the power switch on the back of the unit
and start the BEA 750 by pressing the power key.
5. If the following screen appears during the system
start, press the <F11> key to open the boot mana-
ger.
6. Enter password "ia4kd".
7. Select the USB stick as start-up device on the
screen that appears.
i
The designation of the USB stick is different from
the designation below, depending on the product
used.
? The software starts in a prompt after a few se-
conds.
i
If only the path X:\WINDOWS\SYSTEM32\>_ appears
in the command line, the system must be restarted
by pressing the power key.
8. Read and follow the on-screen instructions.
"
The operating system is restored.
Robert Bosch GmbH
Recovery via USB | 1 687 370 330 | 7
1.4 Installing BEA 750 country variants
1. When the following display appears, insert the up-
date USB stick.
i
If an update USB stick is not available, e. g. in the
case of OTP customers or many country variants,
it can be ordered separately. In exceptional cases,
PKG files are available for download as a ZIP archive
in the general overview of all software versions in
EDIS.
2. Select <Continue>.
3. Read and follow the on-screen instructions.
"
The country variant is installed.
1.5 Configuring the operating system
settings
1. Switch on the BEA 750.
2. Select "Settings >> Language"
3. In the list of languages displayed, select the desired
language and confirm by pressing "Next".
4. Select "Settings >> Operating system".
5. Make the settings for date, time, printer or WLAN.
"
Restart the BEA 750.
1.6 Device configuration
1. Switch on the BEA 750.
2. Select "Settings >> Device configuration".
3. Select the Bluetooth type of connection.
4. Enter the Bluetooth MAC address.
5. Press <F12>.
"
Device configuration is completed.
en
|
1 689 978 638 2019-04-08