Advertisement
prsncln ENv05.qxd 4/29/04 10:37 AM Page 6
How to Use Your Automatic Shower Cleaner
3. Close shower curtain or door in the 15 seconds before
dispensing starts.
4. Dispenser automatically shuts off and returns to stand-by
mode when dispensing is complete.
To change bottle:
1. When bottle is empty, hold
dispenser with one hand and
lift bottle out of dispenser,
turning it right side up.
2. Insert a fresh bottle by turning
upside down and gently
inserting it into dispenser with
label facing away from you.
Firmly press bottle down into
dispenser. You should feel a "pop."
To change batteries:
1. Dispenser will go into stand-by mode and will not activate
when batteries need to be changed.
2. Remove dispenser from shower pipe. If bottle is not empty,
carefully remove it by inverting dispenser over sink and lift-
ing dispenser from bottle. Set bottle aside.
3. Remove battery cover completely from back of dispenser
and insert batteries as illustrated above under "Installation
Instructions." Replace battery cover.
4. Invert dispenser back over bottle and press down snugly.
Reinstall onto shower pipe.
Cleaning dispenser: Wipe clean with a damp cloth.
6
Helpful Hints
• Cleaner is safe for use on most shower and tub surfaces,
including fiberglass, acrylic, and plastic. Do not use on brass,
natural marble or finished wood surfaces.
• Also safe for use on plastic and synthetic shower curtains.
May lighten natural fabrics such as cotton.
• Safe to spray on all personal care products like shampoo,
soap, and bath sponges.
• Will not harm pets.
• Cleaner will dry to a non-slippery surface between showers
to prevent the build-up of soap scum, hard water spots and
mold & mildew stains. As with all daily shower cleaners, run
shower before entering to rinse floor. Always stand on a non-
slip surface when in shower or tub.
• The dispenser sprays a pre-measured amount of daily shower
cleaner throughout your shower from the bottom of the dis-
penser to the shower floor. Because the cleaner is a clear liquid,
it will be difficult to see. Water will run off of treated surfaces in a
smooth sheet instead of beading up and leaving water spots.
• For best appearance, rinse shower/tub occasionally. Cleaner
works best on surfaces wetted during showering. If sprayed
onto dry surfaces cleaner may leave spots which can be
wiped off with a damp cloth.
• The formula works best to prevent the build-up of soap scum,
hard water spots and mold & mildew stains when starting with
a clean surface. However, it will provide a noticeable reduction
in existing mildew stains and soap scum deposits in as little
as two weeks when used on a daily basis.
• Only needs to be used once a day after the last shower to be
effective. Use it at any time, after the last shower in the
morning, afternoon, or evening.
7
Advertisement
