Download Print this page

Mattel Fisher-Price H0785 Instructions Manual page 4

Hide thumbs Also See for Fisher-Price H0785:

Advertisement

e Battery Installation f Installation des piles
e
Soother Battery Compartment
f
Compartiment de la pile de
l'unité apaisante
S
Compartimento de la pila de
la unidad relajante
e
•Locate the electronic unit on the footrest wire. You will
see that there are two battery compartments. The smaller
battery compartment
battery compartment
•First, loosen the screw in the soother battery compart-
ment door with a Phillips screwdriver. Remove the
battery compartment door.
•Insert one "D" (LR20) alkaline battery, as indicated inside
the battery compartment.
•Replace the battery compartment door. Tighten the screw
with a Phillips screwdriver. Do not over-tighten.
•Next, loosen the screws in the toy bar battery compart-
ment door with a Phillips screwdriver.
•Insert three "D" (LR20) alkaline batteries, as indicated
inside the battery compartment.
•Replace the battery compartment door. Tighten the
screws with a Phillips screwdriver. Do not over-tighten.
•Low battery power in the toy bar may cause it to operate
erratically (no sounds/no lights/no bubbling action) and
the toy bar may not turn off. If this should happen,
remove and discard all three batteries in the large battery
compartment
and replace with three, new "D" (LR20)
alkaline batteries.
f
•Trouver l'unité apaisante sur le support du repose-pieds.
Il y a deux compartiments de piles. Le plus petit
sert pour l'unité apaisante, et le plus gros
barre-jouets.
•D'abord, dévisser la vis du couvercle du compartiment des
piles de l'unité apaisante avec un tournevis cruciforme.
Retirer le couvercle du compartiment des piles.
•Insérer une pile alcaline D (LR20) comme indiqué à
l'intérieur du compartiment.
•Replacer le couvercle du compartiment des piles. Serrer la
vis à l'aide d'un tournevis cruciforme. Ne pas trop serrer.
•Ensuite, dévisser les vis du couvercle du compartiment des
piles de la barre-jouets avec un tournevis cruciforme.
S Colocación de las pilas
e
Toy Bar Battery Compartment
f
Compartiment des piles de la
barre-jouets
S
Compartimento de pilas de la
barra de juguetes
powers the soother; the larger
powers the toy bar.
, pour la
+
e
1.5V
– Soother
f
1,5 V – Unité
apaisante
S
1,5V – Unidad
relajante
e
Shown Actual Size
f
Dimensions réelles
S
Se muestra a tamaño real
f
•Insérer 3 piles alcalines D (LR20) comme illustré à
l'intérieur du compartiment.
•Replacer le couvercle du compartiment des piles. Serrer
les vis à l'aide d'un tournevis cruciforme. Ne pas
trop serrer.
•Si les piles de la barre-jouets sont faibles, il se peut
qu'elle ne fonctionne pas bien : les bulles, les sons et les
lumières seront inexistants, et il sera peut-être impossible
d'éteindre la barre-jouets. Si c'est le cas, retirer et jeter les
trois piles du grand compartiment
par trois piles alcalines D (LR20) neuves.
S
•Localizar la unidad electrónica en el tubo del reposapiés.
Hay dos compartimentos de pilas. El compartimento de
pila más pequeño
grande
acciona la barra de juguetes.
•Primero, desajustar el tornillo de la tapa del comparti-
mento de la pila de la unidad relajante con un destornil-
lador de cruz. Quitar la tapa del compartimento.
•Introducir una pila alcalina tipo 1 x "D" (LR20) x 1,5V
como se muestra dentro del compartimento.
•Cerrar la tapa del compartimento. Ajustar el tornillo con
un destornillador de cruz, sin apretar en exceso.
•Luego, desajustar los tornillos de la tapa del comparti-
mento de pilas de la barra de juguetes con un destornil-
lador de cruz, y retirar la tapa.
•Introducir tres pilas alcalinas tipo 3 x "D" (LR20) x 1,5V
como se indica dentro del compartimento.
•Cerrar la tapa del compartimento. Ajustar los tornillos
con un destornillador de cruz, sin apretar en exceso.
•Si las pilas de la barra de juguetes están gastadas es
posible que funcione erráticamente (sin sonido/sin
luces/sin acción de burbujas) y que no se desactive. Si
esto llega a pasar, sacar y desechar las tres pilas del
compartimento de pilas grande
nuevas pilas alcalinas tipo 3 x "D" (LR20) x 1,5V.
4
4
"D" (LR20)
e
1.5V x 3
– Toy Bar
f
1,5 V x 3
Barre-jouets
S
1,5V x 3 – Barra
de juguetes
et les remplacer
acciona la unidad relajante; el más
y sustituirlas por tres

Advertisement

loading