Overhead Rigging - JB Systems Light SW-416 Operation Manual

ENGLISH
FUNCTIONS
(FRONT)
1. Power Switch: turns the unit ON / OFF.
2. Power Cord : supplies main power to the fixture.
3. DMX Input: receives incoming DMX signal
4. DMX Output: transmits the incoming DMX signal to another DMX fixture.
5. Dip Switches: These switches are used to assign a DMX address to the unit.
6. Power Output: It is used to connect four different fixtures, such as lighting effects.
7. Channel LEDs: is lit when the channel is on.
8. 19 Inch Brackets: you can mount the SW-416 in different ways:
19" Rackmounting, possibility 1
Wall Mounting
( Make sure there is a distance of 1 cm between
the SW-416 and the wall. Otherwise you could
damage the back of the unit )
9. Channel Fuses: Protects the individual channels. Replace a broken fuse always with a fuse with the
same rate.
10. Main Fuse: Protects the mains input of the unit. Replace a broken fuse always with a fuse with the same
rate.
11. Main Earth connection
JB SYSTEMS®
OPERATION MANUAL
19" Rackmounting, possibility 2
Truss Mounting
3/25 SW-416 DMX SWITCH PACK
ENGLISH
FUNCTIONS
(REAR)
1. Power LED: Is lit when the unit is ON.
2. Channel LEDs: These Leds show which of the channels are on

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 Locate the device in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
 The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
CONNECTIONS
( MAINS INPUTS/OUTPUTS)
The unit is supplied with a power plug appropriate to its voltage and destination. Should any other
connections be required they must be carried out with the following configuration.
Earth = Green/Yellow cable
Neutral = Blue cable
Live = Brown cable
JB SYSTEMS®
OPERATION MANUAL
4/25 SW-416 DMX SWITCH PACK