Garland ROLL&COMB 302EUS-V21 Instruction Manual page 9

Start up of the machine:
Press the security button
(1) and without letting go of
it, pull upwards the bottom
switch On/Off (2). Once it
has started, let go of the
security button.
Stopping the machine:
Let go of the bottom switch On/Off.
After stopping the machine, the comber will
not stop immediately. Wait until it has stopped
before carrying out any maintenance work on
the machine or before transporting the machine.
6.MACHINE USAGE
Use this machine only for jobs for which it
has been designed. The use of this machine
for any other jobs is dangerous and can cause
dangers to the users and/or to the machine.
Do not place hands or feet under the comber.
Maintain all body parts well clear from all moving
elements when the machine is in use.
Before starting the comber, check that the
moving elements are not in contact with any
object.
Should you slip or fall, let go of the handle
immediately.
Do not rely solely on the security elements of the
machine, use your common sense.
Do not use this machine if fatigued, sick, if you
have had medicines, drugs or alcohol. Lack
of sleep or fatigue can cause accidents and
damages.
Do not use this machine at night, with fog or
with reduced visibility. You must be able to see
and control the working area.
Never leave the machine unattended.
Do not allow anybody to enter the working area.
The perimeter is no less than 15 meters and
nobody should enter this working area as it is a
danger zone.
Clean the working area and remove any
obstacles that could cause accidents.
Always regulate the machine on a flat and stable
surface.
1
Do not use accessories on the machine except
those recommended by our company. Use of
non recommended accessories could cause
severe damages to the user, to the people close
by and to the machine.
2
Avoid using the machine when the ground
is humid. Be particularly careful if using the
machine after it has rained as you might slip
more easily.
It is mandatory to switch off the engine when
transporting the machine between working
areas.
6.1. FIXING THE MACHINE AND GUIDANCE
Whilst working, always hold the comber with
both hands. Always be behind the comber and
push the machine forward. Do not run with the
comber, walk at a constant speed that allows the
machine to comber the lawn.
6.2. ADJUSTING THE WORKING HEIGHT
the comber to stop before adjusting the height
adjustment. The comber need a few moments to
stop completely after stopping the engine.
To regulate the height adjustment, press the
lever outwards and move it or up or down to the
desired spot.
9/52
Attention! Stop the machine and wait for
English