Yamaha YFM250X 2002 Supplementary Service Manual page 13

1 Cable guide
2 Main switch
3 Fuel tank breather hose
4 Carburetor overflow hose
5 Reverse switch lead
6 Neutral switch lead
7 Starter motor lead
8 Throttle cable
9 Rear brake cable
È Route the main switch lead and indicator light lead
to the side of the cable guide.
CABLE ROUTING
É Insert the carburetor air vent hose, rear brake
breather hose, and final gear case breather hose
into the air duct after routing them through the fuel
tank grommet.
Ê Route the carburetor overflow hose between the
engine and upper rear engine mount and then
between the engine and swingarm. Make sure that
the hose is not pinched.
Ë Fasten the starter motor lead to the frame with the
plastic clamp. Route the starter motor lead over the
throttle cable and rear brake cable.
Ì Bend the cable guide after routing the cables.
– 5 –
SPEC