Oxford Garden CLASSIC ROCKER Assembly Instructions

CLASSIC ROCKER
ASSEMBLY INSTRUCTIONS

COMPONENTS

Right Arm Assembly
Quantity: 1
5
Seat
Quantity: 1

HARDWARE

A Dowels
Quantity: 28

FINISHING ITEMS

Medium Grit Sandpaper.
NOTE: A hammer (not provided) will be needed for the assembly of this bar chair.
NOTE: If the furniture is going to be placed on a concrete or tile patio, it should first be rinsed well to
remove the sawdust that may cause some staining.
GLUING INSTRUCTIONS: Correct assembly of this chair requires glue to be applied to the final assembly
joints using the supplied glue. To properly glue these joints follow the directions below:
a. Lay the assembly part flat and apply a liberal amount of glue into the mortise using the brush and
glue supplied. Use the brush to make sure the glue is thick on the inside walls of the mortise.
b. Apply a liberal amount of glue to the complete tenon using the brush to make sure the glue has contact with the entire tenon.
c. Assemble the parts as instructed in the instruction steps. After assembling the glued parts, use a damp
cloth or sponge to clean up any excess glue from the outer surface of the furniture.
15 Kingbrook Parkway, Suite 100 Simpsonville, KY 40067 p. 877.866.3331
Left Arm Assembly
Quantity: 1
Back
6
Quantity: 1
B Wood Screws
Quantity: 4
Right Rocker
Quantity: 1
7
Front Seat Rail
Quantity: 1
C Wood Glue D
Quantity: 1
Left Rocker
Quantity: 1
Back Seat Rail
8
Quantity: 1
Wood Glue
Brush
Quantity: 1
f. 502.719.8888 oxfordgarden.com
Ver. 06.30.20