DeLonghi PALACE Instruction And Installation Booklet page 24

6. ANTIFREEZE (green LED)
To switch from night mode to frost protection mode, press the MODE key once. In this
operating mode, the temperature cannot be adjusted by the User but is fixed at 7°C.
In frost protection mode, the arrow indicates the snowflake symbol and 7°C is displayed
on the screen. This mode prevents the room temperature from dropping below 7°C.
[Fig. 15]
7. PROGRAMMING MODE (green LED)
This is a 24/7 programmable thermostat. In this operating mode, the thermostat adjusts
the temperature following the daily program, using the comfort temperature or the night
reduction temperature set.
To switch from frost protection mode to programming mode (programmable thermostat),
press the MODE key once.The word "PRO" will appear on the screen.
The function is indicated by the arrow on the clock symbol (the clock at the bottom of the
screen). In the "clock" section of the screen, the current time of the day is displayed only if the
time and day of the week have been set.
The daily program is displayed on the left of the screen. An arrow at the top of the screen
indicates the current mode (comfort or night).
The temperature selected in this mode is displayed on the screen. To program the thermostat,
go to paragraph 9.
CAUTION: the time and day of the week must be adjusted to use the programming mode
(par. 2). Overwise programming mode will use only comfort temperature. To change the
comfort (or night) temperature, switch to comfort (or night) mode and then use the PLUS
and MINUS keys to change the temperature parameters.
[Fig. 16; 16a; 16b]
8. OPEN WINDOWS DETECTION
The function can detect the open window state, the function is activated when the temperature drops
quickly, (when a window is open in the room). When the window open state is detected, the screen
displays "OPn" and the radiator switches to antifreeze at 7 ° C.
The status automatically ends if the window is detected closed or by pressing on the MODE button.
[Fig. 17]
9. WEEKLY PROGRAMMING
To switch to weekly programming, you must:
- Already have set the time and day of the week (the screen indicates the current time steadily)
(Par. 2)
- Be in PROGRAMMING mode - chronothermostat - with an indicator on the clock.
To enter this mode, press the MODE key for 5 seconds until the word "PRO" appears on the
screen ("FP" will appear first and then "PRO").
In this mode, ever day of the week can be programmed.
23
24H/24 ET 7J/7