Additional Information; Troubleshooting - Sony DEV-3 Operating Manual

Additional information

Troubleshooting

If you run into any problems using this
product, follow the steps below.
 Check the list (p. 42 to 43), and
inspect this product.
 Remove the power source, attach
the power source again after about 1
minute, and turn this product on.
 Press RESET (p. 53) using a pointed
object, and turn this product on.
If you press RESET, all settings,
including the clock setting, are reset.
 Contact your Sony dealer or local
authorized Sony service facility.
See the Digital Recording Binoculars Handbook

(p. 12) for details on the symptoms of this
product, and "PMB Help" (p. 37) on connecting
this product to a computer.
The power does not turn on.
Attach a charged battery pack to this product

(p. 17).
Connect the plug of the AC Adaptor to the

wall outlet (wall socket) (p. 20).
This product does not operate even when
the power is set to on.
It takes a few seconds for this product to be

ready to shoot after the power is turned on.
This is not a malfunction.
Disconnect the AC Adaptor from the wall

outlet (wall socket) or remove the battery
pack, then reconnect it after about 1 minute. If
this product still does not work, press RESET
(p. 53) using a pointed object. (If you press
RESET, all settings, including the clock setting,
are reset.)
GB

The temperature of this product is extremely

high. Turn off this product and leave it for a
while in a cool place.
The temperature of this product is extremely

low. Leave this product with the power turned
on. If you still cannot operate this product,
turn off this product and take it to a warm
place. Leave this product there for a while,
then turn on this product.
This product gets warm.
This product may become warm during

operation. This is not a malfunction.
The power abruptly turns off.
Use the AC Adaptor (p. 20).

Charge the battery pack (p. 17).

Pressing START/STOP or PHOTO does not
record images.
Press MODE to turn on the

(Photo) lamp.
This product is recording the image you have

just shot on the memory card. You cannot
make any new recordings during this period.
The memory card is full. Delete unnecessary

images.
Total number of movie scenes or photos

has exceeded the recordable capacity of this
product (p. 45). Delete unnecessary images.
The recording stops.
The temperature of this product is extremely

high/low. Turn off this product and leave it for
a while in a cool/warm place.
"PMB" cannot be installed.
Check the computer environment or

installation procedure required to install
"PMB" (p. 34).
"PMB" does not work correctly.
Quit "PMB" and restart your computer.

(Movie) or