Operation - Westfalia 11 11 95 Instruction Manual

Preparation
1. The standard nozzle (10) is already attached. If desired screw the needle
nozzle (2) onto the glue gun.
2. Attach the small support bracket and the large support bracket (4 resp. 5)
into the openings (3) at the front part of the small and large gun for a
secure stand.
3. Clean the surface you want to glue and make sure it is dry and without
grease or dust. Roughen smooth surfaces before gluing them.
Using the large Glue Gun
1. Connect the power cord (1) to the heating station and to a wall outlet.
2. Insert a long glue stick into the gun from the rear opening (11) and then
press the trigger (6) gently several times to push the stick into the barrel
as far as it will go. This way the glue stick lies firmly on top of the heating
element.
3. Place the glue gun on the connection socket (8). The LED (12) on the
handle will light up. Allow the glue gun to heat up for approx. 5 minutes.
4. Take off the gun from the heating station, hold the nozzle over the point
you want to glue.
5. Press the trigger until the melted glue flows from the nozzle.
6. Apply the glue directly, do not dispense. Press down the surface with the
melted glue within 15 seconds. Continue to press the glued parts together
for several seconds.
7. During pauses, put the glue gun back on the heating station to heat up
again. You can glue with the glue gun up to 8 - 10 minutes, according to
the adhesion, the quantity and the size of the surfaces to be glued. Allow
excess melted glue to flow onto the drip tray (7). When melted glue does
not come out from the nozzle, put the gun back on the heating station to
heat up.
8. When the stick cannot be pushed any further by the trigger, put in a new
stick into the opening.
Do not try to take out the old glue stick, simply put in a new stick. The old
stick will remain in the gun until it has been completely melted.

Operation

6