Specifications - Gemini GSYS-4000 User Manual

— —®
6 gemlni
GSYS—4000
DUAL 12" BLUETOOTH PARTY SYSTEM
SPECIFICATIONS
AUDIO
Output Power 4000W Peak
Frequency Range 20Hz to 20KHz
Input Voltage 100V — 240 VAC
50/60Hz + 10%
SPEAKERS
Subwoofers Dual 12"
Tweeters Dual 4"
OTHER
S/N Ratio: z70dB
Input Sensitivity: 500mVi50mV
Input Voltage: AC100V-240V 50/60Hzi10%
Support electric guitar/keyboard: Yes
FM Antenna: Telescopic FM antenna (20 FM
preset channels)
USB port: support MP3/WAV playback
Specifications subject to change without
notification for improvement.
TROUBLESHOOTING
UNIT WILL NOT POWER ON
- Check power cord is securely connected to mains
power and wall outlet is powered and not
switched.
CAN'T CONNECT VIA BLUETOOTH
- Make sure BLUETOOTH on your portable
device is turned on.
- Make sure GSYS—4000 is in BLUETOOTH
mode.
- Verify another Bluetooth device is not
currently connected to unit.
CAN'T HEAR BLUETOOTH OR EXTERNAL
DEVICE
- Verify power is on and volume is turned up on your
external device.
MICROPHONE IS NOT AUDIBLE
- Slowly raise MIC LEVEL until mic is audible.
- Make sure microphone is fully plugged in and turned
on (if switched).
For all other issues, please contact GEMINI support
at 1-844-GEMlNI9
Responsible Party Name:
Innovative Concepts & Designs
Company address:
107 Trumbull St-F8 2nd Floor
Elizabeth, NJ, 07206 USA C
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules.
The operation is subject to the following two
conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.
This device and its antenna(s) must not be co-located
or operating in conjunction with any other antenna or
transmitter.
The device has been evaluated to meet general RF
exposure requirements. The device can be used in
portable exposure conditions without restriction.
Note: This equipment has been tested and found
to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules. This
equipment generates, uses and can radiate radio
frequency energy and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
interference to radio or television reception, which
can be determined by turning the equipment off and
then on, the user is encouraged to try to correct the
interference by one or more of the following measures:
~ Reorient or relocate the receiving antenna.
~ Increase the separation between the equipment and
receiver.
~ Connect the equipment to a different outlet so that the
equipment and receiver are on different branch circuits.
~ Consult the dealer or an experienced radio/TV
technician for help.
FCC ID: 2AE6G-GS)/S4000
ce Fc IEI E