Radina U2 User Manual v2.2 Table of contents: Main features ............................3 Start working with Radina U2 ......................4 Programming software: Programmer Radina P3 .................. 5 3.1. General Settings ..........................5 3.2. Settings for the digital inputs ......................6 3.3.
User Manual v2.2 1. Main features Radina U2 is a communication device with the main purpose to transmit data from security panels and/or sensors through UHF radio channel. Using the advantages of the most advanced communication technologies Radina U2 provides the most secure connection with monitoring center, using various ways of transmition –...
Radina U2 User Manual v2.2 2. Start working with Radina U2 Connect the programmer Radina P3 to the USB port of your computer. If drivers are not installed, please download them from the download section on our web site http://www.inova- bg.com/en/downloads.html.
Radina U2 User Manual v2.2 3. Programming software: Programmer Radina P3 3.1. General Settings Protocol – Select Protocol – LARS, LARS II*, Electronics Line Band – Programmer Radina P3 can work with both UHF and VHF transmitters. An appropriate band must be selected here, corresponding to the type of device which is connected.
Radina U2 User Manual v2.2 Backup Count – Number of used backups Backup 1,2,3,4 – Backup frequencies for the radio transmitting. Can be from 400 to 468 MHz with maximum of four symbols after the decimal point. For each digital input you can choose whether to transmit or not on the backup frequencies.
Radina U2 User Manual v2.2 3.3. Saving the new configuration There is two ways to save the configuration on each device - with or without a password. This is done by the buttons - Write Settings and Write Settings with Password.
In case you changed the settings and can’t reach the device or if you forgot your password, Radina U2 is capable to return to its factory defaults. For this purpose you must disconnect from power supply, push and hold the button for hardware reset and reconnect to the power supply.
Radina U2 User Manual v2.2 6. Hardware AC connection Each of the digital inputs could be used as a “Hardware AC” input. In this mode it will monitor the AC and generate a message for “AC Loss/AC Restore”. Inova-bg Ltd. 2012...
7. Mounting in the security panel box The mounting screw on the top of Radina U2 should be used for proper mounting of the device in the box of the security panel. The pictures below shows how to use it.